Leon Mk2
| Gear mechanism and housing - assembly overview |
| 1 - | Countersunk bolt, 25 Nm |
| 2 - | Articulation flange |
| q | removing and fitting → Chapter |
| 3 - | Sealing cover of the input shaft |
| q | Two possible versions: with and without circlip |
| q | Removing and installing (with gearbox installed) → Chapter |
| q | Always replace. |
| 4 - | Circlip |
| q | For the ball bearing of the input shaft |
| 5 - | Reverse light switch, -20 Nm |
| 6 - | Seal |
| q | replace |
| 7 - | Oil empty plug |
| q | Hexagon socket head bolt, 30 Nm |
| q | Multi-point socket head bolt, 45 Nm |
| 8 - | Seal |
| q | replace |
| 9 - | Locking bolt for the selection shaft - 30 Nm |
| 10 - | Bolt - 15 Nm + 90° (1/4 turn further) |
| q | With captive washer |
| q | replace |
| 11 - | Bolt - 15 Nm + 90° (1/4 turn further) |
| q | Without washer |
| q | replace |
| 12 - | Gear selection mechanism |
| q | Dismantling and assembling → Fig.. |
| q | Removing with gearbox installed: |
| – | Remove the battery and its bracket |
| – | Remove the control cables and gear selector mechanism. |
| – | Unscrew the locking screw and pull out the gear mechanism → Item. |
| 13 - | 20 Nm |
| q | replace |
| 14 - | O ring |
| q | replace |
| 15 - | clutch housing |
| q | Repairing → Chapter |
| 16 - | Gearbox |
| q | Repairing → Chapter |
