seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Assembly sequence: Gearboxes ?without? securing clip A for the sealing cover of the drive shaft > < I = Cover plate of the drive shaft ?with? circlip A and II = cover plate of the drive shaft made from plastic: Removing and inst

Leon Mk2

Input shaft, output shafts (drive shafts), differential gear and gear prongs of the gearbox - assembly overview
   
Input shaft, output shafts (drive shafts), differential gear and gear prongs of the gearbox - assembly overview
1 -  Output shaft for 1st - 4th gear
q   Dismantling and assembling → Chapter.
q   Installation position → Fig.
2 - Selector rod with selector fork for 1st and 2nd gears
q   Installation position → Fig.
3 - Selector rod with selector fork for 3rd and 4th gear
q   Installation position → Fig.
4 - Output shaft for 5th, 6th and reverse gears
q   Dismantling and assembling → Chapter.
q   Installation position → Fig.
5 - Selector rod with selector fork for 5th and 6th gear
q   Installation position → Fig.
6 - Selector fork for reverse gear
q   Installation position → Fig.
q   Identification → Fig.
q   Repairing → Chapter
7 - Input shaft:
q   Dismantling and assembling → Chapter.
8 - Reverse shaft
q   With thrust washer.
9 - Thrust washer
10 - Vent valve
q   Connect to slave cylinder → Item
11 - clutch housing
12 - Join ring for the input shaft
q   Replace → Chapter
13 - O ring
q   replace
q   assemble on the cable connection
q   Moisten with brake fluid before installing
14 - Slave cylinder with clutch release bearing
15 -  12 Nm
q   3 off
q   replace
16 - Countersunk bolt, 25 Nm
17 - Stub shaft
q   removing and fitting → Chapter
18 - Differential
q   Dismantling and assembling → Chapter.

   
Installation position of shafts and selector rods in gearbox
1  - Input shaft:
2  - Output shaft for 1st - 4th gear
3  - Secondary shaft for 5th/6th and reverse gear
4  - Reverse shaft
A  - Control rod with prongs for 3rd and 4th gear
B  - Control rod with prongs for 1st and 2nd gear
C  - Control rod with prongs for 5th and 6th gear
D  - Reverse gear prong → Remark
1)  Seats with several gearboxes on the gear selection shaft of the 5th / 6th gear -C- prong. Identification of different types of reverse gear selector forks → Fig.
  N34-10022

Assembly sequence: Gearboxes ?without? securing clip A for the sealing cover of the drive shaft > < I = Cover plate of the drive shaft ?with? circlip A and II = cover plate of the drive shaft made from plastic: Removing and inst