| t
| The bolts and nuts to be used to secure covers and casings must be released and tightened diagonally in stages when no tightening order is specified. |
| t
| Especially delicate parts, such as clutch pressure plates, must not be distorted. Loosen and tighten bolts and nuts in stages in diagonal sequence. |
| t
| The specified tightening torques are for non-lubricated nuts and bolts. |
| t
| Replace bolts and self-locking nuts. |
| t
| In all bolted unions, ensure that supporting surfaces and bolts and nuts are only waxed after installation, if this is necessary. |
| t
| Threaded holes where there had been self-locking bolts or bolts with thread fixing agent must first be cleaned (for example, with a threading male). If this is not done, the bolts may break when removed again. |
| t
| Check the thread pitch so that the cleaning of the correct thread tap can be used in order not to damage the thread. |
|
|
|
