seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Gear selection mechanism: Removing and installing > < Selector lever cables: Removing and installing

Leon Mk2

Gear selection mechanism: Assembly overview
Gear selection mechanism: Assembly overview
→ Chapter „Gear selection mechanism: Removing and installing“
→ Chapter „Gear selection mechanism: removing and fitting“
→ Chapter „Gear selection mechanism: adjustment“
  Note
Grease all bearing bushes and contact surfaces with approved lubricating grease → Spare parts catalogue.
   
1 - Base plate
q   Straighten tabs for removal
q   Replace
2 - Seal
q   Replace if there are restrictions
3 - Gear lever
4 - O ring
q   Replace if there are restrictions
5 - Securing clip
6 - Selection control cable
q   Removing and installing → Chapter
q   Adjusting → Chapter
7 - Gear selector cable
q   Removing and installing → Chapter
q   Adjusting → Chapter
8 - Retainer washer
9 - Frame
q   For compression spring → Item
10 - Bearing shell with damper element
11 - Panel
12 - Bush
13 - Retainer washer
q   Removing and installing → Fig.
14 - Compression spring
15 - Bush
16 - Bolt, 6 Nm
17 - Retainer washer
18 - Mounting bush
19 - Gear lever guide
20 -  10 Nm
21 - Seal
q   Between gear lever casing and vehicle underbody
q   Self-adhesive
22 - Gear lever casing
23 - Mounting bush
24 - Bearing pin
25 - Guide sleeve
q   Press into gear lever casing
26 - Compression spring
q   Installing → Fig.
27 -  5 Nm
28 - Selector bracket

   
Removing and installing securing clip
–  Keep gear lever fixed -2-.
–  Press in spacer bush -3- in direction of arrow.
–  Remove safety washer -1-.
  A34-0595
Installing compression spring
–  From above, attach reinforcement -A- of compression spring onto guide -1-.
–  Pull compression spring reinforcement downwards -B- and attach it guide from below.
  Note
This is shown in the figure with the selection bracket removed.
  A34-0601

Gear selection mechanism: Removing and installing > < Selector lever cables: Removing and installing