Leon Mk2
| Selector lever cable (counterhold of the and relay lever made of metal): Assembly overview |
Note| t | Lubricate bearing positions and sliding surfaces. |
| t | Allocate grease using → Electronic parts catalogue (ETKA). |
| t | Do not kink selector cables. |
| 1 - | Gear selector cable |
| q | Connect to cable end-piece → Item |
| q | Installation position → Chapter |
| q | Secure to gate selector cable with cable tie → Fig. |
| q | From 11.06, modified attachment to gear lever inside selector mechanism → Item |
| 2 - | Selection control cable |
| q | Connect to cable end-piece → Item |
| q | Installation position → Chapter |
| q | Secure to gear selector cable with cable tie → Fig. |
| q | From 11.06, modified attachment to gate selector lever inside selector mechanism → Item |
| 3 - | Retainer washer |
| q | Always replace. |
| q | Discontinued in selector mechanisms from 11.06 → Chapter |
| 4 - | Lever protection box |
| 5 - | Retainer washer |
| q | Always replace. |
| q | Take care not to damage selector cables when removing. |
| 6 - | Hexagon bolt, 20 Nm |
| q | 3 off |
| q | For cable support bracket |
| 7 - | Cable support bracket |
| q | Metal |
| 8 - | Grommet |
| q | Cable support bracket mounting on gearbox |
| 9 - | Spacer |
| 10 - | Cable attachment |
| q | After installing, adjust selector mechanism → Chapter |
| q | To secure selection control cable to idler rod |
| q | Do not mix up. The element fastening the cable selector to the idler rod and fastening the connector cable to the selector rod are different. |
| q | Allocation → Fig. |
| 11 - | Cable attachment |
| q | After installing, adjust selector mechanism → Chapter |
| q | Secures gear selector cable to gearbox selector lever |
| q | Do not mix up. The element fastening the cable selector to the idler rod and fastening the connector cable to the selector rod are different. |
| q | Allocation → Fig. |
| 12 - | Retainer washer |
| q | Always replace. |
| q | Not required if the idler rod is plastic |
| 13 - | Retainer washer |
| q | Always replace. |
| 14 - | Mounting bush |
| 15 - | Idler rod |
| q | Metal |
| q | Installation position → Fig. |
| q | After installing, adjust selector mechanism → Chapter |
| 16 - | Runner |
| 17 - | Gearbox selector lever |
| q | Can be renewed with the selector mechanism installed |
| q | Installing → Fig. |
| q | Installation position → Fig. |
| q | After installing, adjust selector mechanism → Chapter |
| q | From 06.06, smaller diameter of support pin for cable end-piece → Fig. |
| 18 - | Hexagon nut → Item |
|
|
| Cable end-piece for: | Gap „a“ |
| 1 - Gear selector cable to gearbox selector lever from 06.06 | 8.5 mm |
| 2 - Gear selector cable to gearbox selector lever through 05.06 | 10 mm |
| 2. - Gate selector cable to metal relay lever | 8 mm |
| 2. - Gate selector cable to plastic relay lever → Chapter | 10 mm |
|
|
| Support pin for gear selector cable end-piece | Dimension „a“ |
| Through 05.06 | 10 mm |
| From 06.06 | 8.5 mm |
|
|
|
|
|
|
