Leon Mk2
| Control unit: Assembly overview |
| 1 - | Selector unit |
| q | Consists of selector shaft and selector shaft cover |
| q | Removing and installing → Chapter |
| 2 - | Reverse light switch, 20 Nm |
| q | Apply a fine layer of lubricating grease → Parts catalogue |
| 3 - | Locking pin |
| q | To adjust the gear selection mechanism |
| q | Remove → Fig. |
| q | Insertion → Fig. |
| 4 - | Idler rod |
| q | Installation position → Fig. |
| q | May be plastic or metallic |
| 5 - | Mounting bush |
| q | Not required if the idler rod is plastic |
| 6 - | Seal |
| q | Remove with extractor -T20143- |
| q | Replace → Chapter |
| 7 - | 25 Nm |
| q | Self-locking |
| q | Always replace |
| 8 - | Gearbox selector lever |
| q | Installation position → Fig. |
| q | Can be replaced with the gearbox drive mechanism in place |
| 9 - | Cap |
| q | For gearbox breather |
| 10 - | Retainer washer |
| q | Not required if the idler rod is plastic |
| 11 - | Sealing cap |
| 12 - | Spring |
