Leon Mk2
| Assembly overview: pedal cluster |
| 1 - | Bulkhead |
| q | With support for mounting bracket |
| 2 - | Seal |
| q | Always renew |
| q | Between mounting bracket and bulkhead |
| q | Self-adhesive |
| q | Bond to mounting bracket |
| 3 - | Mounting bracket |
| q | For mounting clutch pedal |
| q | Is provided with damping in some equipment variants → Fig. |
| q | Removing and installing → Chapter |
| 4 - | Bolt |
| 5 - | Over-centre spring |
| q | Removing and installing → Chapter |
| 6 - | Bearing bush |
| 7 - | Pivot pin |
| 8 - | Clutch pedal |
| q | Removing and installing → Chapter |
| 9 - | Mounting bracket |
| q | To remove and install, separate master cylinder from clutch pedal using the pliers -T10005- ⇒ Removing and installing clutch pedal → Chapter |
| 10 - | Seal |
| q | Always renew |
| q | Between master cylinder and mounting bracket |
| 11 - | Master cylinder |
| q | Removing and installing after removal of mounting bracket → Chapter |
| 12 - | Clutch position sender -G476- |
| q | Removing and installing → Chapter |
| q | Can be checked in „guided fault finding“ of vehicle diagnosis, testing and information system -VAS 5051- |
| 13 - | Clip |
| q | Pull out clip to stop to remove and install pipe/hose line or pipe line |
| 14 - | Supply hose |
| 15 - | 25 Nm self-locking hexagonal nut |
| q | 3 off |
| q | For mounting bracket to bulkhead |
| q | Always renew |
| 16 - | Hexagon nut 25 Nm |
| q | Always renew |
| 17 - | Stop |
| q | For clutch pedal |
|
|