During the following work, ensure that no brake fluid lands on longitudinal member or gearbox. If this does happen, clean the affected areas thoroughly.
–
Seal the supply hose leading to the clutch master cylinder using the sealing tool -T10249/1-.
Note
The hose clamps -3094- that appear in the figure can be ignored.
Remove line -1- from master cylinder as follows:
–
Release securing clip -3- using screwdriver and pull off line -1- with O-ring -2-.
Caution
Do not depress clutch pedal after removing slave cylinder.
Remove line -4- from bleeder -1- as follows:
–
Release securing clip -2- using screwdriver or pointed object and pull line -4- with O-ring -3- off bleeder -1-.