seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Torque settings > < Removing

Leon Mk2

Installing
Installing
Installation is carried out in the reverse order, noting the following:
   
Some cars have damping -arrow- on the mounting bracket/clutch pedal.
  Note
t  Renew self-locking nuts.
t  Allocate all components according to → Electronic parts catalogue „ETKA“.
  N30-10195
–  Install crash bar -1- and tighten bolt -2- to specified torque → Chapter.
Vehicles with knee airbag
–  Install knee airbag → Interior equipment; Rep. gr.69.
Continuation for all vehicles
–  Install trim and cover below trim on drive side → General body repairs, interior; Rep. gr.68.
  N34-11204
–  Push line -1- with seal -2- onto connection of master cylinder -4- until securing clip -3- engages audibly.
–  Test line by tugging on it.
–  Fold back the supply hose to its original form as required.
–  Hydraulic clutch system: bleeding of air → Chapter.
–  Install battery → Electrical system; Rep. gr.27.
–  Install the complete air filter housing, if previously removed → Rep. gr.23.
  A30-0156
Right-hand drive vehicles
–  If present, fold heat shield around the pipe/hose line -arrows-.
  N34-11205

Torque settings > < Removing