seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Specified torques > < Detaching

Leon Mk2

Installing
Installing
  Note
Renew self-locking nut.
   
–  Make sure that support -1- is located on operating rod -2-.
–  Press retainer into notch in clutch pedal -3- until it can be heard to engage.
–  Insert over-centre spring in mounting bracket from above.
  A30-0133
–  Receptacle -arrow- for tip -A- of clutch pedal must be vertical.
–  Fit link pin on clutch pedal into corresponding socket in over-centre spring.
–  Press clutch pedal slightly, push bolt through and tighten self-locking nut.
  N30-0421
Some cars have damping -arrow- on the mounting bracket/clutch pedal.
  N30-10195
–  Return it to installation position.
–  Install crash bar -1- and tighten bolt -2- to specified torque → Chapter.
Continuation for all vehicles
  N34-11204
–  Fit universal joint -2- to steering box and screw in new bolt -1- → Running gear, axles, steering; Rep. gr.48.
–  Perform basic setting for steering angle sender -G85- using vehicle diagnosis, testing and information system -VAS 5051-.
Vehicles with knee airbag
–  Install knee airbag → Interior equipment; Rep. gr.69.
Continuation for all vehicles
–  Install trim and cover below trim on drive side → General body repairs, interior; Rep. gr.68.
  N48-10004

Specified torques > < Detaching