SEAT Workshop Service and Repair Manuals

Detaching –  Move driver seat as far back as possible and put steering wheel in highest position. –  Remove driver side compartment and cover → General body repairs, interior; Rep. gr.68. Vehicles with knee airbag –  Remove knee airbag → Interior equipment; Rep. gr.69.

Continuation for all vehicles –  Remove footwell vent -1- → Heater; Rep. gr.80.

Appearance of footwell vent may differ from illustration. –  Remove impact absorber -1-. To do this, remove the bolt -2-. Continuation for all vehicles –  Unbolt fuse holder beneath dash panel and lay to side → Electrical system; Rep. gr.97. –  Unhook relay carrier beneath dash panel and lay to side → Electrical system; Rep. gr.97.

–  Unscrew nuts -arrows- and remove footwell trim.

–  Unscrew bolt -1- and detach universal joint -2- from steering box.

If fitted, remove damping -arrow- from lower area of clutch pedal mounting bracket.

–  To do this, remove lock washers -A- for damping. –  Pull off damping.

–  Push damping upwards in area of upper securing nut -1- above clutch pedal -A- in -direction of arrow-.

–  Unbolt clutch pedal -1- from mounting bracket -3-. To do this, remove nut -2- and pull out bolt -5-.   Note The clutch pedal remains hooked to operating rod of master cylinder. –  Pivot clutch pedal down slightly and take over-centre spring -4- out of mounting bracket.