seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Specified torques > < Detaching

Leon Mk2

Installing
Installing
Installation is carried out in the reverse sequence; note the following:
The holes in the cable end-pieces have different diameters.
Allocation of cable end-pieces → Chapter
–  Spread a small amount of grease on pin -arrow- of gearbox selector lever -2-.
   
Allocate grease using → Electronic parts catalogue (ETKA).
–  Renew securing clip -1- each time it is removed.
–  Fit relay lever and cable end-piece together → Chapter.
–  Insert gate selector cable in cable end-piece.
–  Align selector housing parallel to body.
l  Distance to body must then be the same on both sides.
–  Install centre console → General body repairs, interior; Rep. gr.68.
  N34-11116
–  Renew clamp -arrow-.
–  Install underbody panels → General body repairs, exterior; Rep. gr.50.
–  Assemble exhaust system free of tension and attach tunnel cross member → Rep. gr.26.
Adjust selector mechanism → Chapter.
–  If removed, install complete air filter housing → Rep. gr.23 or → Rep. gr.24
–  Follow steps required after connecting battery → Electrical system; Rep. gr.27.
  N34-1201

Specified torques > < Detaching