Leon Mk2
|
WARNING
Note| Lubricate the support points and contact surfaces with polyurea grease. Allocation: → Electronic spare parts catalogue. |
| 1 - | Bolt. |
| q | 15 Nm |
| q | replace |
| 2 - | Selector shaft lever |
| 3 - | Cable support bracket |
| q | For the selector lever cable in the gearbox |
| 4 - | Bolt. |
| q | 13 Nm |
| q | For adjusting selector lever cable |
| 5 - | Locking plate |
| q | replace |
| 6 - | Selector lever cable |
| q | Do not bend or kink |
| q | Replace the gear selection cable if the protective sheath is damaged |
| q | verification and adjustment → Chapter |
| q | removing and fitting → Chapter |
| q | Do not grease the shaft ring or ball socket |
| 7 - | Nut |
| q | 10 Nm |
| q | 4x |
| 8 - | Rubber stop for the selector lever |
| q | Clipped onto selector mechanism |
| 9 - | Selector lever and gear selector mechanism |
| q | Operate manual release mechanism → Chapter |
| q | removing and fitting → Chapter |
| q | With integrated printed circuit for selector mechanism (selector lever - E313 -), do not touch |
| q | Incorporates Tiptronic switch -F189- and selector lever lock solenoid -N110 -. These components can be tested in the „Guided Fault Finding“ mode → Vehicle diagnostic tester. |
| q | The Tiptronic switch -F189- and selector lever lock solenoid -N110- can only be renewed together with the complete selector mechanism unit |
| 10 - | Insertion spring |
| 11 - | Bolt. |
| q | 3.5 Nm |
| 12 - | Bolt. |
| q | 3.5 Nm |
| 13 - | Forcing plate |
| 14 - | Bearing pin |
| q | For securing selector lever cable to selector mechanism |
| 15 - | Retaining clip |
| q | For mounting the selector lever cable to the shift unit of the operating mechanism. |
| q | replace |
| 16 - | Panel |
| q | For shift unit |
| q | With gasket attached |
| 17 - | Nut |
| q | Self-locking |
| q | replace |
| q | 9 Nm |
| 18 - | Bolt. |
| q | 8 Nm + 90° |
| q | replace |
| q | For cable support bracket to gearbox |
