Leon Mk2
|
| 1 - | Output shaft 3 |
| 2 - | Needle bearing |
| 3 - | Synchromeshed gear for reverse gear |
| 4 - | Synchro-ring |
| 5 - | Locking collar and synchro-hub for reverse gear |
| q | Dismantling and assembling → Chapter. |
| 6 - | Circlip |
| 7 - | Stop ring |
| 8 - | Parking lock gear |
| q | Smooth side points towards shaft end, »crowned« side towards reverse gear for synchromeshed gear |
| 9 - | Support |
| 10 - | Bearing cap |
| q | removing and fitting → Chapter |
| l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
| 11 - | Bearing cap |
| q | removing and fitting → Chapter |
| l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
| 12 - | Thrust piece |
| q | Removal is not mandatory |
| q | Lift out with screwdriver |
| q | Press in by hand using locking pin -T10043- to stop |
| 13 - | Support |
