Leon Mk2
|
1 - | Output shaft 3 |
2 - | Needle bearing |
3 - | Synchromeshed gear for reverse gear |
4 - | Synchro-ring |
5 - | Locking collar and synchro-hub for reverse gear |
q | Dismantling and assembling → Chapter. |
6 - | Circlip |
7 - | Stop ring |
8 - | Parking lock gear |
q | The smooth side points to the end of the shaft, the »bulged« side to the mobile pinion of the reverse gear. |
9 - | Support |
10 - | Bearing cap |
q | Removing and installing → Chapter>>>>>>>> |
l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
11 - | Bearing cap |
q | Removing and installing → Chapter>>>>>>>> |
l | Bearing races are not allowed to be swapped over. They are paired with the bearing. |
12 - | Thrust piece |
q | Removal is not mandatory |
q | Lift out with screwdriver |
q | Press in by hand using locking pin -T10043- to stop |
13 - | Support |