SEAT Workshop Service and Repair Manuals

1)    Adjustment work is required if these components are replaced => Adjustment overview Page 39-193.

• Seal
• ◆ Lever out with a screwdriver
• ◆ Always renew
• Centralizing nut, 160 Nm
• ◆ Removing
• ◆ Installing => Page 39-149
• ◆ Before screwing onto shaft bevel gear, coat with locking fluid
  D 000 600 A2
• Viscous coupling
• ◆ Functional check
  => Page 39-108
• ◆ Store only in installation position

• Pinion housing1)
• ◆ Removing
• ◆ Pressing in => Page 39-149
• ◆ Servicing shaft bevel gear bearing => Page 39-165
• Hexagon bolt, 25 Nm
• O-ring
• ◆ Always renew
• Shim S3
• ◆ The identification holes (arrows) face towards top of rear axle housing
• ◆ Note thickness
• ◆ Adjustment overview
  => Page 39-193
• Rear axle housing1)