Leon Mk2
| Reverse gear brake: general fitting diagram |
| 1 - | Gearbox casing |
| 2 - | Circlip |
| q | Remove by levering with a screwdriver |
| 3 - | Support disc |
| q | Determine thickness |
| q | Fitting → Anchor |
| 4 - | Inner disk -B1- |
| q | Number of parts |
| 5 - | Outer disk -B1- |
| q | Number of parts |
| 6 - | Thrust disc |
| 7 - | Plate spring |
| q | Note installation position: large diameters should coincide → Anchor |
| 8 - | Circlip |
| q | Remove by levering with a screwdriver |
| 9 - | Spring support plate |
| q | With springs |
| q | Fit in the piston → Item → Anchor |
| 10 - | Seal |
| q | Always replace |
| 11 - | Seal |
| q | Always replace |
| 12 - | Piston -B1- |
| q | The corresponding gearbox code is assigned to this spare part |
| q | Removing → Anchor |
| q | Before fitting the oil seals, moisten them with ATF |
| 13 - | Segment ring |
| q | Checking the correct adjustment |
| q | Do not overstretch |
| 14 - | Gearbox casing cover |
| 15 - | O-ring |
| q | Always replace |
| 16 - | Locking bolt |
| q | 8 Nm |
