SEAT Workshop Service and Repair Manuals > Leon Mk2 > Automatic gearbox 099 - 4-speed | Automatic gearbox, control, assembly, housing | Dismantling and assembling gearbox | Dismantling and assembling planetary gearbox

Pressing -K1- onto -K3-

–	Moisten O-ring with ATF.

–	Insert new O-ring in the recess in the turbine shaft -arrow-.

–	Clip axial needle bearing -1- with washer to 3rd and 4th gear clutch -K3- -2-.

–	Ensure the tool press surfaces are flat and not damaged.

–	Prepare -K1- and -K3- for pressing as shown here.

–	Before pressing on, align -VW 418 A- centrally onto surface for axial needle bearing (this illustration shows -K3- from below).

–	Press clutch -K1- on carefully until stop is perceptible.

–	Do not exert further pressure onto clutches!

SEAT Workshop Service and Repair Manuals