seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Front wing assembly > < Removing and installing front wing

Leon Mk2

Front wing removal
Front wing removal
  Note
The procedures for removal and assembly described below correspond to the left front wing. The procedures for the right front wing are similar.
–  Remove the moulding from the front bonnet → Chapter.
–  Remove front bumper → Chapter.
  Note
t  Given that the removal of the side indicators is only possible in one direction, do this carefully; with the indicator fitted, the side of the indicator in the allotment and elastic clip is not immediately clear.
t  If an attempt is made to lever the indicator off on the side of the elastic clip, the indicator or the paintwork may be damaged.
   
–  Carefully press the indicator with the lever -U30800- on the side of the allotment -1-, overcoming the resistance of the plastic clip -2- from the other side of the indicator and extract it. (If necessary, cover the paintwork with adhesive tape).
–  Separate the electrical connector.
–  Remove end plate → Chapter
–  Removing side member trim → Chapter.
  N94-0289
–  Remove bolts -2- and detach holder -1-.
  E66-10136
–  Unscrew bolts -2-, -3-, -4- and -5-.
–  Carefully remove front wing-7-.
  Note
t  To protect the front wing when supported on one of its parts, insert suitable material between the wing and its contact surface.
t  There is protective foam on the lower section of the wing -6-.

   

Front wing assembly > < Removing and installing front wing