seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Rear bumper cover, Altea 2009: General assembly overview > < Bottom grille in the bumper cover Altea 2009 - assembly

Leon Mk2

Rear bumper trim: Assembly overview
Rear bumper trim: Assembly overview
  Note
Installation and removal procedures of the Altea FR are carried out in the same way as the Altea 04. Differences between both vehicles: their optical appearance.
   
1 - Rear bumper trim
q   PP/EPDM Material
q   Removing and fitting → Chapter
2 - Bolt
q   8 pieces
q   2.5 Nm
3 - Torx bolt
q   1.5 Nm
4 - Rear tyre well moulding
q   Removing and fitting → Chapter
5 - Screw dowel
6 - Guide for the bumper trim
7 - Bolt
q   8 + 8 each
q   2.5 Nm
8 - Moulding attachment
9 - Bolt
q   5 + 5 each
q   2.5 Nm
10 - Torx bolt
q   7 pieces
q   20 Nm
11 - Rear crossbeam
12 - Guide dowel
q   screwed onto a threaded pin
13 - Torx bolt
q   4 pieces
q   2.5 Nm

   

Rear bumper cover, Altea 2009: General assembly overview > < Bottom grille in the bumper cover Altea 2009 - assembly