Leon Mk2
| Removing and installing moulded part of the B-pillar |
| 1 - | B-pillar trim |
| Removing: |
| q | Unclip cover -7- |
| q | Remove bolts -6- and detach trim outwards. |
| Installing: |
| q | With rear door open, insert trim in retainer |
| q | Attach cover with rear door closed as shown in upper and lower illustrations sections ? |
| q | Screw in front bolt -6-. |
| q | The outer lip of the rear door window seal should make even contact all the way down the trim panel. |
Note| Ensure that the seal does not press too hard onto the trim, as the lip of the seal could otherwise project and cause wind noise. |
| q | Screw in rear bolt -6- with door open. |
| q | Press grommet -5- into trim. |
| q | Push on cover -7- from below. |
| 2 - | Bolt. |
| q | 1.5 Nm |
| 3 - | Mounting bracket |
| 4 - | Clip |
| 5 - | Grommet |
| 6 - | Bolts and washers |
| q | 5 Nm |
| 7 - | Cover |
