seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Tailgate, self-adhesive company emblem ?EXEO ST?: replace > < Company emblem, front ?SEAT? Week 45.11 >: Removing and installing

Leon Mk2

Tailgate, self-adhesive company emblem „EXEO“: replace
   
Tailgate, self-adhesive company emblem „EXEO“: replace
t  Hot-air blower -SAT 1416-
t  Digital thermometer -SAT 4013-
t  pressure tool -T20098-
t  Lever -U 30800-
t  Adhesive strip remover -VAS 6349-

t  Tailgate, self-adhesive company emblem „EXEO“: remove → Anchor
t  Tailgate, self-adhesive company emblem „EXEO“: attach → Anchor
Removing
–  Before removing the self-adhesive company emblem on the tailgate, heat it up to approx. 25°C with a hot air gun -SAT 1416-.
–  Using the lever -U 30800-, remove the company emblem from the tailgate.
–  Remove existing adhesive residue of adhesive tape using adhesive strip remover -VAS 6349-.
Installing
–  Clean the area of the tailgate where new self-adhesive company emblem is to be applied with isopropanol or heptanes alcohol.
–  Then treat the area where the new self-adhesive company emblem should be applied using silicone cleaner.
–  Allow to dry well.
–  Using the hot air blower -SAT 1416-, heat the application area on the bodywork to approx. 35°C. Check the temperature using the digital thermometer -SAT 4013-.
   
–  Remove the protective film -2- of the self-adhesive company emblem „EXEO“.
–  Apply the new self-adhesive company emblem -3- using the dimensions shown in the figure.
–  Apply the self-adhesive company emblem -3- and press down with pressure tool -T20098- with force of approx 5 kg.
–  Remove the protective film -1- of the self-adhesive emblem.

   

Tailgate, self-adhesive company emblem ?EXEO ST?: replace > < Company emblem, front ?SEAT? Week 45.11 >: Removing and installing