SEAT Workshop Service and Repair Manuals

Rear door electric window motor: Removing and installing

Special tools and workshop equipment required

t	Torque wrench kit -SAT 8010-

t	Lever -T20043-

t	Lever -U 30800-

t  Removing → Anchor t  Fitting → Anchor. Removing   WARNING Disconnect the battery earth strap before carrying out any work on the electrical system.   Note During removal and installation, take note of small amounts of deviations depending on the equipment.

–  Remove the cover -1- and the loudspeaker grille -2- using the lever -U 30800-.

–  Remove bolts -1-. –  Disconnect plug -3-. –  Detach the lining upholstery -2- using lever -T20043-.

–  Disconnect the loudspeaker connector -arrow-.

–  Remove the arrester -1- by pulling in the direction of -arrow A- and then in the direction of -arrow B- from its mount. –  Remove the hook of the operating cable -2- of the interior door handle.

–  Unscrew the screws -2- in the electric window motor -3-. –  Separate the window lifter motor -3- of the window lifter unit -1-, that is located behind the subframe lining. –  Separate the connector -4- and remove the window lifter motor. Fitting. Fit in reverse order from removal, remembering the following: Tightening torques → Chapter   WARNING Before mounting the door trims, the function of the components must be checked. → Chapter „Synchronisation and storage of window course“. → Chapter „Automatic raising or lowering: Commissioning“.