SEAT Workshop Service and Repair Manuals

Front door window - removing and assembly See corresponding table for tools and equipment depending on applicability for Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Torque wrench kit -SAT 8010-

t  Lever -U 30800- t  Removal → Anchor t  Installing → Anchor Removal –  Remove the interior lining from the door: → Bodywork, interior assembly work; Rep. Gr.70   Note If power window motor cannot be operated, proceed as described in → Chapter. –  Temporarily connect the power window switch connectors to the door control unit and turn the ignition key to the contact position.

–  Pry off caps -2- with lever -U 30800- and move window until screws -1- for fastening power window clamping jaws are visible through opening in door unit sub-frame.. Loosen screws -1- to separate power window clamping jaws and then move ignition key out of contact position.

–  Tip rear portion of window -1- toward front in -direction of arrow- thereby lifting carefully and remove from window guide -2-. Installing

–  Check whether screws -1- for fastening power window clamping jaws are visible through opening in door unit sub-frame.. If necessary move power window mechanism.

–  Carefully insert window -1- in -direction of arrow- into window guide -2-. Check whether window is seated correctly in window guide.

–  Press window in -direction of arrow- against upper edge of door frame. –  Allow window to slide down and press slightly in direction of -arrows- to ensure that: t  it is properly seated in the power window clamping jaws and

t  in complete contact with the window guide.

–  Tighten screws -1- to fasten power window clamping jaws. t  Tightening torque: 10 Nm. –  Check to ensure that power window system functions correctly → Anchor. Window in front door: Check for proper function Follow instructions below: –  Temporarily connect the power window switch connectors to the door control unit and turn the ignition key to the contact position. –  Actuate appropriate switches to move window up and down and check whether window moves easily and properly. l  If the window moves normally, continue installation. → Anchor l  If the window does not move normally adjust as specified in the instructions below:

–  Move window until screws -1- for fastening power window clamping jaws are visible through opening in door unit sub-frame.. Loosen screws -1- to separate power window clamping jaws. –  Allow window to slide down and press slightly in direction of -arrows- to ensure that: t  it is properly seated in the power window clamping jaws and

t  in complete contact with the window guide.

–  Tighten screws -1- to fasten power window clamping jaws. t  Tightening torque: 10 Nm. –  Close caps -2-. –  Check again for correct operation. → Anchor Continue installation observing following: t  Perform operation for synchronising and storing window operation only when no further manipulations are required → Chapter. t  Check tightening torques. → Chapter