SEAT Workshop Service and Repair Manuals

Window shaft seal on outside of front door: removing and installing See corresponding table for tools and equipment depending on applicability for Seat / VW / Audi / Skoda → Chapter. Special tools and workshop equipment required

t  Lever -U 30800-

t  Wedge -T10039/1- t  Removal → Anchor t  Installing → Anchor Removal l  It is NOT necessary to remove the entire window guide to remove the outer window shaft seal –  Remove interior lining on front door: Remove the lining from the door: → Bodywork, interior assembly work; Rep. Gr.70 –  Remove the window . → Chapter   Caution Remove window guide uniformly without bending. The inner part of the window guide is metal. If it is bent, it is not possible to return it to the original shape.

–  Remove only rear part of window guide -1-: for this purpose first drive window guide out of door frame -2- by pulling toward outside by hand. If required use lever -U 30800- as aid and position at each mounting wedge -Arrow- on window guide. –  Continue to remove window guide downward until it unhooks from the window shaft seal on the outside.   Caution Remove window shaft seal uniformly without bending. The inner part of the window shaft seal is metal. If it is bent, it is not possible to return it to the original shape.

–  Use lever -U 30800- as aid to remove clips -1-.

–  Use flat screwdriver of appropriate side to turn each mounting clip -1- until the groove is in a horizontal position. –  Remove outer window shaft seal uniformly, if required use wedge -T10039/1- as aid. Installing   Caution install window shaft seal uniformly without bending. The inner part of the window shaft seal is metal. If it is bent, it is not possible to return it to the original shape. Always replace damaged clips. –  Position new clips in each opening in window shaft seal. l  The grooves should be in a horizontal position.

–  Position window shaft seal -3- on door and press in each mounting clip -2- with aid of flat screwdriver and turn 90º, until groove is in a vertical position. –  Press in clips -1-.   Caution Install window guide uniformly without bending. The inner part of the window guide is metal. If it is bent, it is not possible to return it to the original shape.

–  Install part of window guide removed -1-: For this purpose first press end of guide in until it catches in the outer window shaft seal - the groove -2- on the retaining wedge -Arrow- for the window guide must be flush with the door frame. –  Press against the window guide with your fingers at the height of the retaining wedge. –  Continue to install window guide in direction of upper rear edge of door frame in the same manner until it is completely arrested in the door frame. –  Install window guide inner lip. –  Install window → Chapter –  Install interior lining on front door: → Bodywork, interior assembly work; Rep. Gr.70