Leon Mk2
| Installation |
| Carry out the following work: |
| For the additional seal |
| – | Immediately before bonding, clean bonding surface -1- thoroughly with adhesive remover D 002 000 10. |
| l | Bonding surfaces must be free of dust and grease and there should be no adhesive residues. |
| – | Thread the additional seal -1- into sill panel seal -3- and fasten clip -5- on. |
| – | Align additional seal -1- in accordance with the markings -8-. |
| – | Pull protective film off adhesive tape -4- and press additional seal on firmly. |
| For the sill panel seal |
| – | Press sill panel seal -3- together with clips -6- into side panel. |
| – | Press sill panel seal -3- onto wheel housing -2-. |
| – | Press sill panel seal -3- together with clips -7- into side member. |
