seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Glass cover for the sunroof - adjusting > < Panorama roof with glass cover: installation overview

Leon Mk2

Glass cover: removing and installing
Glass cover: removing and installing
Special tools and workshop equipment required
   
t  Torque wrench kit -SAT 8010-
  L00-10226
t  Lever -U 30800-
  W00-2169
Removing
–  Move the sunblind to the back.
–  Press the button to open the sun roof.
–  Undo the upper part of the interior dustguard -3-
–  Remove the Torx bolts-1- fastening the glass cover.
–  Release the upper part of the outer bellow.
–  Remove the glass cover with the reinforced guide-2- (The glass cover and reinforced guide form a single unit).

Installing
Zero position
  Caution
When assembling the glass cover, the guide runners should be at the rear end of the rail.
The following conditions must be present in order to remove and install the gear shift: the motor and the ignition must be turned off, the ignition key removed and the door opened.
   
Place the glass-1- under the rubber seal-2- on the front polycarbonate cover -3-.
Guide and lower glass cover. While inserting retainers/guides into pane guide.
Insert the upper part of the outer bellow.
  E60-10013
–  Insert bolts-1-, but do not tighten to the final torque value.

–  Adjust the glass cover → Chapter.
–  After the alignment of the glass cover tighten bolts -1- (tightening torque: 5 Nm).
   

Glass cover for the sunroof - adjusting > < Panorama roof with glass cover: installation overview