SEAT Workshop Service and Repair Manuals > Leon Mk2 > Body | Bodywork, exterior installation work | Sliding roof | Panorama sliding sunroof (Arvin-Meritor)

Panoramic sliding roof normalisation run

Note

t	After renewal of glass panel, motor, tilting mechanism or sun blind, a normalisation run must be carried out for the corresponding drive.

t	Roll-back function is switched off when establishing reference points.

Establishing reference points of sliding sunroof motor

Ignition is switched on.

Rotary switch must be in „Sliding sunroof closed“ position.

–	Pull rotary switch -1- downwards and hold during whole process to establish reference points (approx. 20 s) in this position.

–	When establishing reference points, glass panel first closes and then moves approx. 200 mm towards the rear.

–	After glass panel is closed again, establishment of reference points is finished and rotary switch must be released.

Establishing reference points for sun blind motor

Ignition is switched on.

–	Press „Close“ pushbutton for sun blind -3- and hold down. Keep in this position during the entire standardisation process (about 20 seconds).

–	When establishing reference points, sun blind first closes and then moves approx. 200 mm towards the rear.

–	After sun blind has been closed completely again, normalisation run is finished and actuation button can be released.

SEAT Workshop Service and Repair Manuals