seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing rear side airbag crash sensor, front passenger sideG257 > < Side airbag crash sensor on front passenger sideG180

Leon Mk2

Removing and installing rear side airbag crash sensor, driver sideG256
Removing and installing rear side airbag crash sensor, driver side -G256-
  Note
Rear side airbag crash sensor on driver side -G256- is located in front of rear wheel housing on driver side.
removing
  WARNING
Observe general safety regulations when working on airbag, belt tensioner and battery isolator units (pyrotechnic components) → Chapter.
–  Disconnect vehicle battery → Electrical system; Rep. gr.27.
–  Remove CD changer if there is one → Communication; Rep. gr.91.
–  Remove seats of third row of seats → Chapter.
–  Undo the C-pillar trim → Chapter.
–  Remove roof end strip → Chapter.
–  Remove D-pillar trim → Chapter.
–  Removing lock carrier cover → Chapter.
–  Remove the connecting piece between sill panel strip and luggage compartment trim → Chapter.
–  Remove luggage compartment side trim → Chapter.
   
–  Disengage the connector locking element and remove the plug connector -1- of the crash sensor -3-.
–  Remove bolt -2- (6 Nm).
Installation
–  Installation is carried out in reverse order.
–  switch ignition on.
  WARNING
Ensure that nobody is in vehicle.
–  Reconnect vehicle battery → Electrical system; Rep. gr.27.
  N69-10344

Removing and installing rear side airbag crash sensor, front passenger sideG257 > < Side airbag crash sensor on front passenger sideG180