seat Workshop Repair Guides

SEAT Leon Mk2 Service and Repair Manuals - Workshop Manuals

ABOUT US
Driver's side front door trim, installation > < Driver's side front door lining, general installation overview

Removing Front Door Lining on Driver's Side - Leon Mk2

Front door lining, driver's side, removal
Front door lining, driver's side, removal
  WARNING
Disconnect the battery earth strap before carrying out any work on the electrical system.
  Note
During removal and installation, take note of small amounts of deviations depending on the equipment.
   
–  Lower glass approximately halfway.
–  Turn off the ignition and all electricity consumers.
–  With the ignition switched off, disconnect the earth lead from the battery → Starter motor, voltage supply; Rep. gr.27.
–  Remove interior trim -1- using the lever -U 30800-.
–  Remove the plug connector for electric mirrors -2-.
–  Remove the lock cylinder casing → Front doors/ parts/central locking system; Rep. gr.57.
–  Detach loudspeaker grille -12-using lever -U 30800-.
–  Detach lining cover in the door -13- using the lever -U 30800-.
–  Unscrew the screws -10- (2x).
–  Detach upper connector cover -11-using lever -U 30800-.
–  Disconnect the plug connector of the electric window lifters.
–  Unscrew the screws -8- (2x).
–  Detach the upholstery of the trim -9- using removal pliers -T20065-, starting with the upper part.
–  Loosen the window clamps and remove glass → Windows; Rep. gr.64.
–  Unscrew the screws -5- (4x) of the loudspeaker -7-.
–  Remove the loudspeaker -7-and disconnect the connector.
–  Unscrew the screws -4- (2x).
–  Unscrew the screws -6- (5x).
–  Unscrew the screws -14- (2x).
–  Remove front panel lining -3- from door by raising it and extracting it towards the door hinge side.

   
–  Unhook the locking device for the cable tension cover -1- in the door trim upholstery. Press the securing hooks of the door lining -arrow A- and remove the locking device from the guide in the door trim upholstery -arrow B-.
–  Unhook the control cable hook -2-.
  E70-0045
–  Undo fastening clips-7- from door -8-.
–  Detach connector from the tweeter - 10-.
–  Unscrew bolts -9-.
–  Remove the window riser mechanism from the front panel lining of the door -1- .
–  Undo the bolts -5- and remove the airbag sensor.
–  Disconnect the connector -4- of the lock -3-.
–  Remove the led -2-.
–  Remove the cable harness from its fixing on the front door panel lining -1-.
  Note
Insert a protective device between the surface where the trim should be lent against and its contact surface to prevent the possibility of dirt entering.

   

Driver's side front door trim, installation > < Driver's side front door lining, general installation overview