| 1 - | Glass scraper (normal) |
| –
| Remove the support plate from the base of the mirror. |
| –
| Eliminate PUR adhesive material from the mirror support plate with a wire brush. |
| –
| Grind down the three distancing granules on the contact surface to adhere. To do this place a sheet of 360/400 abrasive paper on a flat surface. |
| –
| The flattened surface must be kept free from dirt and grease. |
| –
| Grind down the adhesive material and the windscreen primer with a glass scraper until reaching the ceramic layer. |
| –
| Clean contact surfaces with isopropyl or heptopropyl alcohol. |
Caution | Do not damage the ceramic layer. Scratches will always be visible. |
|
| –
| Cut the nylon net material to exactly the size of the mirror base. |
Note! | Use hand protection (rubber gloves). |
| –
| Apply a uniform layer of adhesive to the base of the mirror. |
| –
| Place the nylon net material on the mirror base. |
| –
| More glue must be added to the nylon net material from the tube. |
| You have 30 seconds from the time you place the nylon netting onto the glue to the moment when you fit the mirror pressing it against the windscreen. |
| –
| Press the mirror base firmly against the windscreen for 15 seconds (not too hard). |
| –
| Remove excess adhesive with a cloth. |
Note! | After 15 minutes the inside mirror can be fitted. |
|
|
|
