Leon Mk2
| Assembly overview - backrest cover and cushion |
Note| The assembly overview refers to the 2/3 backrest on the right. The 1/3 backrest on the left is similar. |
| 1 - | Backrest cover |
| q | Removing and installing backrest cover with backrest cushion → Chapter |
| q | Separating and assembling backrest cover and backrest cushion → Chapter |
| q | For correct version, refer to → Electronic spare parts catalogue |
| q | After installation, check that there are no creases in seat. |
| 2 - | Wire |
| q | Encased in foam in cushion |
| q | For attaching backrest cover to backrest cushion |
| 3 - | Shaped rail |
| q | Sewn to backrest cover |
| q | For attaching backrest cover to backrest cushion |
| 4 - | Upholstery clip |
| q | For attaching backrest cover to backrest cushion |
| q | replace |
| q | When installing, fit in same location using upholstery clip pliers -V.A.G 1634-. |
| 5 - | Backrest frame |
| q | removing and fitting → Chapter |
| 6 - | Backrest cushion |
| q | Removing and installing backrest cover with backrest cushion → Chapter |
| q | Separating and assembling backrest cover and backrest cushion → Chapter |
| q | For correct version, refer to → Electronic spare parts catalogue |
| 7 - | Zip |
| q | Sewn to backrest cover |
