Leon Mk2
| Gear selection mechanism: Assembly overview |
Note| Lubricate the support points and contact surfaces with polyurea grease. Allocation: → Spare parts catalogue. |
| 1 - | Rubber seal |
| 2 - | Extension |
| q | Attached to shift unit and secured with bolts → Item |
| 3 - | Bolt, 2 Nm |
| q | 4x |
| 4 - | Shift unit |
| q | Can only be replaced as complete unit |
| q | Removing and installing → Chapter>>>>>>>> |
| 5 - | Selector lever locking solenoid -N110- |
| q | Removing and installing → Chapter>>>>>>>> |
| 6 - | Shock absorber |
| q | Not fitted in all vehicles |
| 7 - | Lock washers |
| q | 4x, always renew |
| q | For securing noise insulation to the function unit for selecting the gears |
| 8 - | Retaining clip |
| q | Secures selector lever cable to shift unit |
| 9 - | Selector lever cable |
| q | Do not bend or kink |
| q | Removing and installing → Chapter>>>>>>>> |
| q | Selector lever cable must be renewed if rubber sleeve is damaged |
| q | When installing, make sure that rubber sleeve on gearbox side is not twisted |
| q | Adjust convergence → Chapter |
| 10 - | O ring |
| q | Always replace. |
