l
| Gearbox must be turned vertical in assembly bracket. Only this way is it possible later to adjust axial play of the clutch without error. |
l
| It is essential that the gearbox be securely clamped in support clamp -VW 313- or engine and gearbox support -VAS 6095- → Chapter. It must not be turned. |
l
| Inside the clutch, the large plate carrier goes through all plates. It must not slip out of the lowest plates. |
l
| The pump shaft of the oil pump is removed. |
l
| Do not install corrugated retaining rings |
Special tools and workshop equipment required |
|
|
|