seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Oil seal between the gearbox and pair of bevelled gears, in the pair of bevelled gears: replace > < Right oil seal of the flange shaft, on the outside of the bevelled gear: replace

Leon Mk2

Renewing needle bearings (polygon bearings) for flange shaft (right-side)
Renewing needle bearings (polygon bearings) for flange shaft (right-side)
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
   
Special tools and workshop equipment required
t  Tightening plate -VW 401-
t  Tightening plate -VW 402-
t  Die -VW 407-
t  Die -VW 412-
t  attachment tool -VAS 3253-
t  Tensioning tool -T10047-

Operation process
–  Remove flange shaft (right-side) → Chapter.
   
–  Fit tensioning tool -T10047- so that markings „B“ on both sections of tensioning tool point towards each other.
l  The steps -arrows- must be below the bearing.
–  Screw both sections together as far as stop.
  N39-0766
–  Remove circlip -A- securing bearings.
–  Rotate shaft when pressing off -arrow- to prevent contact surface of bearings on shaft from being damaged.
  N39-0785
–  Rotate shaft when pressing on -arrow- to prevent contact surface of bearings on shaft from being damaged.
–  Secure bearings with a new circlip.
–  Install flange shaft (right-side) → Chapter.
  N39-0786

Oil seal between the gearbox and pair of bevelled gears, in the pair of bevelled gears: replace > < Right oil seal of the flange shaft, on the outside of the bevelled gear: replace