Leon Mk2
Component description: |
1 - | Diffuser for side window |
q | Removing → Chapter |
2 - | Central diffuser |
q | Removing → Anchor |
3 - | De-icer diffuser |
q | Removing and refitting → Bodywork, assembly work; Rep. Gr.70 |
4 - | Heating and cool air adjustment unit |
q | Incorporating switch for air conditioning -E35- |
q | With switch for cool air ventilator -E9- |
q | With switch for cool and circulating air -E184- |
q | Removing and refitting |
q | Disconnecting and reconnecting |
q | Drive cables: fitting and adjusting |
5 - | Intermediate part for central diffuser |
6 - | Dust and pollen filter |
q | With active carbon filter |
q | Removing and refitting |
7 - | Servomotor for cool/re-circulating air -V113- |
q | Removing and refitting → Chapter |
8 - | Cool air ventilator -V2- |
q | Removing → Anchor |
9 - | Additional resistance for cool air ventilator with overheating fuse -N24- |
q | Removing, cool air ventilator -V2-: removing and refitting → Item |
10 - | Air conditioning and heating |
q | Replacement: |
– | Instrument panel: removing and refitting → Bodywork, interior assembly work; Rep. Gr.70 |
11 - | Joining piece |
q | With the diffusers of the footrest area |
q | Removing → Anchor |
12 - | Heat exchanger |
q | Replacing: |
q | First remove the instrument panel to remove the heating unit. → Bodywork, interior assembly work; Rep. Gr.70 |
q | Fitting: disconnect and connect the heater unit |
q | After removing , replace all the cooling fluid :Heater unit → Chapter |
13 - | Joint between Heat exchanger/dashboard |
q | Note the fitting position |
14 - | Intermediate part for de-icing |
q | Replacing: |
q | First of all, remove the instrument panel to take out the heating unit → Bodywork, interior assembly work; Rep. Gr.70 |
q | Note the fitting position |
15 - | Bowden cables for activating the central and de-icing flaps |
q | Fitting and adjusting → Chapter |
16 - | Central front |
17 - | Conduct for rear seats |
18 - | Diffuser in the footrest area |
q | Only on the passenger side |
19 - | Joint |
q | It must lie flush with the conduct for the rear seats and the joining part |