seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Installing > < Flexible axle (for air distribution): removing and installing|Installation

Leon Mk2

Bowden cable for temperature control: removing and installing
Bowden cable for temperature control: removing and installing
   
–  Fit the rotating control for temperature selection -A- in the position “cold limit”.
–  Remove the Heating control unit -J65- → Chapter.
–  Remove the instrument panel and the crossbeam for the instrument panel (centre tube) → Bodywork, interior fitting work; Rep. Gr.70.
  Note!
So as not to damage instrument panel outside lining, the control panel is only to be placed on a clean workbench covered, for example, with clean cardboard.
  E80-10010
–  Release the insert -D- for the Bowden cable sheath -E- and remove the Bowden cable sheath from the allotment on the heating controls main board.
–  Release the ball on the Bowden cable -F- from the operation lever -G-.
  A80-0248
–  Release the counter support -A- for the Bowden cable sheath -E- and remove the Bowden cable sheath from the heating guide -C-.
–  Release the ball on the Bowden cable -B- from the temperature flap operation lever.
  A80-0248

Installing > < Flexible axle (for air distribution): removing and installing|Installation