| –
| Insert lug -A- in groove -C- and lug -B- in groove -D- of cam plate (lugs -A- and -B- as well as grooves -C- and -D- have different dimensions). |
Note | On insertion, make sure that actuating arms -E- and -F- are correctly positioned on the corresponding pivot pins. |
| Re-install all parts removed in reverse order; note the following: |
| –
| Route wiring harness so that it cannot come into contact with moving components (e.g. control motor lever). |
| –
| Interrogate and erase fault memory ; perform basic setting . |
Note | Check the function of the control motor as follows: connect both contacts “5” and “6” to a plug of the control motor to a 12 V direct current voltage source. Control motor then moves only in one direction as far as stop. Interchanging positive and negative reverses direction. Use the adapter cable for this purpose → Chapter. |
|
|
|
