SEAT Workshop Service and Repair Manuals > Leon Mk2 > Heating, ventilation, air conditioning system | Heating, air conditioning | Heating | Removing and assembling heating components | Removing and installing Bowden cable for temperature adjustment

Removing and installing Bowden cable for temperature adjustment

Removal:

–	Move the rotary control for setting the temperature -A- to the „cold stop“ position.

–	Remove the main board for the heating control elements → Chapter.

Note

The flexible shaft must not be removed.

–	Release fastener -D- of Bowden cable sheath -E- and take Bowden cable sheath out of mounting of base plate for heater controls.

–	Release ball at Bowden cable -F- from actuating lever -G-.

–	Remove the bottom section of the steering wheel housing according to the version of the model → Bodywork, interior fitting work; Rep. gr.68.

–	Remove the driver side footwell trim → Bodywork, interior fitting work; Rep. gr.68.

–	Remove the vent from the foot well area on the left side → Chapter.

Note

The dash panel insert is not illustrated in the figure to provide a better overview of the parts to be removed.

–	Remove the Data bus diagnostic interface -J533--1- → Electrical system; Rep. gr.97

–	Remove bracket -A- for fixing the dash panel insert → Bodywork, interior fitting work; Rep. gr.70

–	Unfasten support bracket -A- of Bowden cable sheath -E- and take Bowden cable sheath out of heater guide -C-.

–	Release ball at Bowden cable -B- from lever of temperature flap.

Installation

Attach in reverse order; note the following:

–	Only fit Bowden cables which have not been kinked and which move freely in sheath.

–	Do not kink Bowden cable.

–	Use the tightening torque → Bodywork, interior fitting work; Rep. gr.68.

SEAT Workshop Service and Repair Manuals