Leon Mk2
Climate control unit (Climatic): Removing and fitting |
1 - | Servomotor for temperature flap -V68- |
q | Removing and fitting |
2 - | Support |
3 - | Bolts |
q | Unscrew the bolts to separate the air distributor body and the evaporator. |
4 - | Cover |
5 - | Servomotor for air recirculation flap -V113- |
q | Removing and fitting → Chapter |
6 - | Air inlet housing |
q | With circulating air flap |
7 - | Upper section of the evaporator housing |
q | Evaporator housing: Deactivating and preparing |
8 - | Lower section of the evaporator housing |
q | Evaporator housing: Deactivating and preparing |
9 - | Evaporator |
q | Removing and fitting |
10 - | Evaporator vent temperature sender -G263- |
q | Removing and fitting → Chapter |
11 - | glove box cooling nozzle |
12 - | glove box cooling hose |
13 - | Additional resistance for the fresh air turbine with overheat fuse -N24- |
q | Removing and fitting → Chapter |
14 - | Fresh-air turbine -V2- |
q | Removing and fitting → Chapter |
15 - | Dust and pollen filter |
q | With active carbon filter |
q | Removing and fitting → Chapter |
16 - | Cover |
q | For the dust and pollen filter |
17 - | Heat exchanger |
q | Removing and fitting → Chapter |
18 - | Heat exchanger covering |
19 - | Air distribution housing |