Leon Mk2
Note
|
1 - | Compressor and alternator bracket |
Removing |
– | Alternator: removing → Electrical system; Rep. Gr.27 |
– | Remove the compressor from the support and fix it to the body with a suitable tool (e.g. soldering wire) → Fig.. |
– | Loosen the bolts that fix the bracket to the cylinder block. |
Fitting |
t | Before fitting, it is necessary to: |
– | Replace fixing bolts. |
t | Tightening torques: tighten the hexagonal screws position A,B,C, and finally, D. |
2 - | Hexagon bolt M10x55 |
q | 50 Nm |
q | 2 units |
3 - | Hexagon bolt M10x45 |
q | 45 Nm |
q | 2 units |
4 - | Compressor |
q | Removing: |
– | Remove the hexagon bolts, → Item. |
– | Remove the compressor from the support and fix it to the body with a suitable tool (e.g. soldering wire) → Fig.. |
q | Poly-V belt routing → Fig. |
5 - | Hexagon M8x100 bolt |
q | 25 Nm |
q | 3 units |
6 - | Dowel sleeves |
q | 2 units |
q | Make sure the cylinder head supports are correctly seated. |
7 - | Tensioning roller |
8 - | Tensioning element for the tensioning roller |
Note
|