Leon Mk2
Installation overview for the manual air conditioning unit |
1 - | Preliminary resistance for the fresh air fan -N24- |
q | Removing and fitting → Chapter |
2 - | Regulating motor for the fresh air and circulation air intake flap-V113- |
q | Removing and fitting → Chapter |
3 - | Fresh-air fan -V2- |
q | Removing and fitting → Chapter. |
4 - | Dust and pollen filter |
q | Also as a combined filter with the odour filter |
q | Removing and fitting → Chapter |
5 - | Air conditioning control unit -J301- |
q | With switch for fresh air fan -E9- |
q | Replace completely |
q | Removing and fitting → Chapter. |
6 - | Flexible shafts |
q | For the temperature flap regulation unit (colour: purple, length 256 mm) |
q | For the air distributor flap regulation unit (colour: blue, length 250 mm) |
q | Removing and fitting → Chapter. |
7 - | Heating elements for the secondary heating (PTC) -Z35- |
q | Only in some vehicles |
q | Assembly overview → Chapter |
8 - | Heat exchanger |
q | Assembly overview → Chapter |
q | Removing and fitting → Chapter |
9 - | Control mechanism for the temperature flap |
q | Removing and fitting → Chapter |
10 - | Gasket with support |
q | Fit it onto the body of the heater with a clip. |
11 - | Evaporator outlet temperature sender -G263- |
q | To remove it, it is necessary to remove the dashboard and extract it laterally. |
q | Check → Vehicle diagnosis, testing and information system VAS 5051 |
12 - | Oil seal |
q | Replace if it has defects. |