seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and fitting the regulating motor for the temperature flap V68|Fitting > < Removing and fitting the regulating motor for the temperature flap V68

Leon Mk2

Removing
Removing
→ Bodywork, interior fitting work; Rep. Gr.70
   
–  Rest the air conditioning unit on the lower part towards the central tunnel with a suitable object.
  E80-0037
–  Remove the floor nozzle, left-3-, screw -4-: 1.5 Nm.
–  Remove the support with the comfort control unit -1- from its fixing by pressing outwards on the upper part and pushing in the direction of the arrow to release it from the fixing.
–  Unscrew the bolts -2- (5 Nm).
  E87-0122
–  Release the wiring harness from the left support -3--arrows-.
–  Remove the screws -2- from the module bracket -1-, torque 12 Nm.
–  Take out the screws -4- and remove the support, torque 25 Nm.
–  Remove the connector -1- and -5-.
–  Carefully cut the cable tie from the wiring harnesses -3- and -4-.
–  Apply light forward pressure to the catch -6-, turn the support with the regulation motor -2- in the direction of the arrow and remove it from the front supports.
  E87-0123
–  Remove the regulation motor from the support.
To do so, press the tabs -arrows- outwards and simultaneously push the regulation motor to remove it from its fixing.
  E87-0076

Removing and fitting the regulating motor for the temperature flap V68|Fitting > < Removing and fitting the regulating motor for the temperature flap V68