Leon Mk2
|
| 1 - | Air distribution housing of the heating |
| q | Do not dismantle further |
| q | For those vehicles without an Additional heating element -Z35- the opening for the Additional heating element -Z35- is covered by the heat exchanger cover |
| q | Lightly grease the support points and the temperature flap guides (for example using G 052 745) |
| 2 - | Bolt |
| 3 - | Air duct to the air vent in the left foot well |
| q | Version “Heating” |
| 4 - | Heating system heat exchanger |
| q | Removing and fitting → Chapter |
| 5 - | Sealing ring |
| q | Replace |
| q | Lightly moisten with liquid coolant and fit correctly into place → Chapter |
| 6 - | Clip |
| q | Replace |
| q | Ensure that it is properly positioned. |
| q | Removing and fitting → Chapter |
| 7 - | Bolt |
| q | Tightening torque: 2.5 Nm |
| 8 - | Coolant tubes |
| q | Remove and fit on the heat exchanger → Chapter |
| 9 - | Sponge material spacer |
| q | Fitted between the grommet and the heating |
| 10 - | Grommet |
| q | Before fitting the heating, fit this in the transversal panel of the vehicle → Chapter |
| q | Fitting → Chapter |
| 11 - | Air flow duct |
| q | Removing and fitting → Chapter |
| 12 - | Dust and pollen filter |
| q | Removing and fitting → Chapter |
| q | Observe replacement intervals → Booklet1 |
| 13 - | Cover for the dust and pollen filter |
| q | Removing and fitting → Chapter |
| 14 - | Air duct to the air vent in the right foot well |
| q | Version “Heating” |
| 15 - | Plug |
| q | Only fitted to vehicles without air duct to rear vent of the centre console |
