seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Tightening torques > < Removal:

Leon Mk2

Installation
   
Installation
Installation is carried out in the reverse sequence; note the following:
  Note
t  Use oil for the hydraulic circuits → Electronic spare parts catalogue (ETKA).
t  Replace the seal -2-.
t  Secure the connecting pieces of the hose lines with securing clips → Electronic spare parts catalogue (ETKA).
–  fix the clutch control slave cylinder onto the gearbox casing. Tightening torque → Item
–  Press in pipe and hose assembly -1- with new seal -2- in slave cylinder connection -4- until safety fastener -3- is audibly secured.
–  Pull pipe and hose assembly to check it is properly secured.
–  Bleed air from hydraulic clutch system → Chapter.
–  Install battery → Electrical system; Rep. gr.27.
  A30-0138

Tightening torques > < Removal: