Leon Mk2
| Clutch clearance between -K1- and -K2-: adjusting |
| Special tools and workshop equipment required |
| t | Base -T20003- |
| t | Bracket -T20020- |
| t | Bracket -T20026- |
| t | Dial gauge |
| Install the components for clutch clearance adjustment without shim → Item → Chapter and → Chapter |
| 1 - | Gearbox casing |
| q | Planet gear installed up to the satellite carrier shaft → Chapter |
| 2 - | Axial needle bearing with washer |
| q | The axial needle bearing faces the satellite carrier shaft |
| q | The washer faces -K3- |
| 3 - | 3rd and 4th gear clutch -K3- with turbine shaft |
| q | On some gearboxes, clutches -K1- and -K3- may be fitted one on top of the other |
| 4 - | O-ring |
| 5 - | Clutch from 1st up to 3rd gear -K1- with turbine shaft |
| 6 - | Shim |
| q | Do not install for clutch clearance adjustment |
| q | 1 or 2 shims can be fitted |
| 7 - | Reverse gear clutch -K2- |
