seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Determine the shim A > < Satellite carrier control measurement
Reverse gear brake B1: adjusting
Reverse gear brake -B1-: adjusting
Special tools and workshop equipment required
   
t  Torque spanners -SAT 8010-
  W00-2760
t  Bracket -T20026-
t  Dial gauge
  W00-2306
1 - Gearbox casing
q   With drive sprocket and satellite carrier fitted
2 - Shim
3 - Outer disk -B1-
q   Number of disks → Chapter
4 - Inner disk -B1-
q   Number of disks → Chapter
5 - Pressure plate
q   Fit the flat side facing the disks
q   Allocate the spare part according to the gearbox codes
6 - Plate spring
q   The rounded side must face the free wheel
7 - Free wheel with piston -B1-
q   Before removing or fitting the free wheel, remove the slide box and the union plugs → Chapter
q   Also remove the gearbox rev. speed sender -G38- → Chapter
8 - Safety ring

   

Determine the shim A > < Satellite carrier control measurement