Leon Mk2
|
|
|
Install the components for satellite carrier adjustment in the gearbox without shim → Item. |
1 - | Drive sprocket |
q | Do not remove it to adjust the planet gear |
q | Drive socket: removal and fitting → Chapter |
2 - | Washer for axial needle bearing |
q | Fit the flat side on the drive sprocket |
3 - | Axial needle bearing |
4 - | Washer for axle needle bearing |
5 - | O-ring |
q | Fit to the satellite carrier → Chapter |
6 - | Satellite carrier |
7 - | Gearbox casing |
q | With drive socket and axial needle bearing |
q | The axial needle bearing remains on the drive sprocket |
q | If the axial needle bearing is worn → Chapter |
8 - | Washer |
9 - | Axial needle bearing |
10 - | Long planet gear |
11 - | Washer |
q | Fit it to the long planet gear → Chapter |
12 - | Axial needle bearing |
13 - | Small planet gear shaft |
14 - | Axial needle bearing |
15 - | Needle bearing |
16 - | Satellite carrier shaft |
17 - | Shim |
q | Do not fit to adjust the satellite carrier |
q | Up to 3 shims can be fitted |
18 - | Washer |
19 - | 30 Nm |
q | Fot the satellite carrier shaft |