Leon Mk2
| Fuel tank with accessory parts: removing and installing |
| 1 - | Cap |
| 2 - | O-ring |
| q | Renew if damaged |
| 3 - | Tank flap unit |
| q | Removing and installing → Bodywork Repairs, installation work, exterior; Rep. Gr.55 |
| 4 - | Breather pipe |
| 5 - | Gravity/overload valve |
| q | To remove, release locking lug and unclip valve upwards out of filler neck |
| q | Check valve for through flow Perpendicular valve: open, valve tilted 90°: closed |
| 6 - | O-ring |
| q | Renew if damaged |
| 7 - | Earth connection |
| 8 - | 4 Nm |
| 9 - | Filler neck |
| q | With anti-return valve |
| 10 - | Dust sleeve |
| q | After fitting the filling neck, fit it over the fuel tank neck |
| 11 - | Fuel tank |
| q | Removing and installing → Chapter |
| 12 - | Heat shield |
| q | Press the heat shield's securing washer firmly against the pin located in the vehicle underbody |
| 13 - | 25 Nm |
| 14 - | Securing strap |
| 15 - | Fuel gauge sender |
| q | Note fitting position on fuel tank → Fig. |
| q | Sender with screens moveable in relation to the upper part |
| 16 - | O-ring |
| q | Renew if damaged |
| q | Coat with fuel when installing |
| 17 - | Flange |
| q | Note fitting position on fuel tank → Fig. |
| 18 - | Cap nut |
| q | Remove and install with turning tool -U-40055A- |
| 19 - | Return pipe |
| q | Blue |
| q | Check for secure seating |
| q | Fitting position → Fig. |
| 20 - | Supply pipe/hose |
| q | Black |
| q | Check for secure seating |
| q | Fitting position → Fig. |
| 21 - | Connector |
| q | Black, 2-pin |
| 22 - | Vent valve |
| q | Checking → Fig. |
| q | Dismantling → Fig. |
| 23 - | Dust sleeve |
| q | For filler neck |
| 24 - | O-ring |
| q | Renew if damaged |
Note!
|
|
