seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing thermostat > < Removing and installing coolant pump

Leon Mk2

Removing and installing coolant temperature senderG62
Removing and installing coolant temperature sender -G62-
t  Removing → Anchor
t  Installing → Anchor
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Collecting tray -T20173-, see equivalent → Anchor
Removing
l  Engine cold.
–  Open filler cap on coolant expansion tank briefly and allow residual pressure in cooling system to dissipate.
  W00-2455
–  Detach the outer -1- and inner -2- engine covers, by pulling them evenly upwards.
–  Remove the air filter housing → Chapter.
  E01-10018
–  Separate the connector -arrow- of the coolant temperature sender -G62-.
  Note
Place a cloth underneath connection to catch escaping coolant.
–  Pull off retaining clip -2- and pull the coolant temperature sender -G62- out of the connecting support.
Installing
Installation is carried out in reverse order, noting the following:
  Note
t  Renew O-ring.
t  Insert new coolant temperature sender -G62- into connection immediately to prevent the coolant from escaping.
t  Hose connections and air pipes and hoses must be free from oil and grease before fitting.
t  Secure all hose connections with the correct type of hose clips (same as original equipment) → Electronic parts catalogue.
–  Install air cleaner housing → Chapter.
–  Check coolant level → Anchor.
  E19-10048

Removing and installing thermostat > < Removing and installing coolant pump